性饥渴的黄蓉与老汉

Main enamel reaction tank, enamel equipment, agitator
Always follow the principle of reliable quality and customer first

Precautions for enamel equipment hoisting

Number of hits:    Update time: 21 / 09 / 25 11:30:09 Source: www.zbshebei. cn close Sharing:
If the enamel equipment is installed by hoisting, the requirements are very high, because the hoisting will be installed at a certain height, and the difficulty will be very high. Before hoisting, we need to pay attention to the following matters:
1. When selecting the hoisting equipment, the equipment with proper lifting capacity should be selected. The weight of the equipment is indicated in detail on the name plate of the enamel reactor and other equipment, as far as the delivered container on the bracket is concerned.
2. Please do not forget to calculate the weight of the support when selecting and determining the power of the lifting equipment, which is usually 15% of the weight of the container. At the same time, in order to avoid any mechanical stress on the large container, it is recommended to use two cranes or a lifting beam.
3. Use intact fiber sling: it is forbidden to use fulcrum to rotate the equipment before lifting the equipment; The enamel reactor should be placed on a wood strip high enough to rotate the equipment to the installation position of pipes, bottom plates and other accessories without damage; Use the lifting rings to rotate the enamel equipment, place the equipment in the position of the next handling operation, and fix the equipment with wooden wedge in the appropriate position.
4. When using the hook and ring, it is strongly recommended to use the hook that matches the lifting lug. When using the hook, make sure that the size of the hook is right, and a small lever will not be formed on the outer wall of the equipment. Handle it with care to avoid any collision of the container.
5. It is recommended to use textile sling to lift the enamel equipment, because the hinge and hook may collide with the enamel reactor vessel, thus damaging the enamel layer.
6. It is forbidden to use the pipe orifice as the lifting lug, and the replacement lug designed on the equipment must be used. If the lifting lug is sealed by metal plate, do not use the lifting lug sealed by metal plate.
When the enamel equipment needs to be hoisted, we should pay attention to the above points. Before hoisting, we may as well make some calculations, so as to reduce the damage to the equipment as much as possible.

性饥渴的黄蓉与老汉_男朋友像疯了一样要我_昨晚他怎么弄你

http://48.juyouguo.cn http://71.juyouguo.cn http://47.juyouguo.cn http://51.juyouguo.cn http://10.juyouguo.cn http://57.juyouguo.cn http://84.juyouguo.cn http://20.juyouguo.cn http://71.juyouguo.cn http://04.juyouguo.cn http://45.juyouguo.cn